Call a TechXPert™ 855.922.7769

Related Resources

Launchtec Selection Chart

Live TechXpert™ Help

Talk to a TechXpert about Launchtec 2 Hole Launcher Blade

Click Here to Chat with a TechXpert™

Launchtec 2 Hole Launcher Blade

SKU# 1700004

$14.99

Item # 1700004

Catalog Page # 159

The no chatter launcher blade.
Full Description
TEMPORARILY OUT OF STOCK
You can still order this!

view similar products

* Required Fields

$14.99
Product Description
Product Description
• Designed to fit Trophy Taker 2 hole arrow rests as well as other rests compatible with a 2 hole blade
• Made from an aerospace quality epoxy composite material
• Less chatter during draw
• Quieter than steel blades
• Will not rust
• Does not suffer from fatigue, more consistent performance, either straight or broken, never bent
• Low bounce, will settle quicker, hence better clearance
• No sharp edges which can damage carbon arrows
* Extra Narrow blade is equivalent to .010"
* Narrow blade is equivalent to .010"
* Wide blade is equivalent to .012"
Related Resources

Launchtec Selection Chart

Similar products

Customer Reviews

Customer Reviews

Read 3 Customer Reviews

Write Your Own Review
Compatible With Spot Hog Review by Mike Sedlak
Value
Quality
Price

Had no problem installing the blade on my Spot Hogg Infinity. I replaced the original counter sunk screws with Hillman 4-40 cap screws from a local ACE store. The blade is significantly stiffer than a carbon steel blade. And unlike the steel blade, there is no bending with the arrow resting on it. Sure, take care when tightening the screws and, yea, it will probably snap if it catches or snags on clothing or a finger sling. But again, until you do something accidentally like that, there's no deflection.

(Posted on 8/17/17)

great product Review by Doug Newquist
Quality
Price
Value

I was concerned about the Spot Hogg screws as well when I first installed. I used blue loctite and only tightened them down snugly, using the long part of the allen wrench so I could not over torque them. X10's and VAPS draw smooth, no chatter, no falling off. Shoot great, no blade bend. There is a little inside blade wear after a while. I replaced mine after a couple of months prior to going to Redding and when I put the new one on did not notice a impact change. The new one shows wear as well but I am going to shoot it for several months and see if I can wear it out or see if it just wears in. Still no fletching contact. I have used all three sizes with x10's Vaps, 23 super drives and X27's , all work great.

(Posted on 5/25/17)

Not compatible with Spot Hogg Rest Review by Travis Eiler
Value
Quality
Price

I was super excited to use an extra narrow laucher blade on my Spot Hogg Edge rest. HOWEVER Launchtec warns not to use spot hogg rest screws; 4-40 x 1/4in countersink screws. Launchtec advises button head or cap screws. 4-40 button head & cap screws (0.110in dia) are too small to hold launcher blade repeatably (blade hole dia = 4mm/0.158in). Launchtec also warns against over tightening as the epoxy is fragile compared to steel. These factors are a recipe for disaster with a Spot Hogg rest. I do not recommend this item if you have a Spot Hogg rest.

(Posted on 5/16/17)

Write Your Own Review

Write Your Own Review

You're reviewing: Launchtec 2 Hole Launcher Blade

  •  
    1
    2
    3
    4
    5
    Quality
    Price
    Value
Log in to access this form without a captcha.

* Required Fields