UltraView UltraGrip for Hoyt Hunting Bows
UltraView UltraGrip for Hoyt Hunting Bows
Share this item:
Description
- Do your hands get cold when you're hunting? The team at UltraView have a solution for you
- This grip is manufactured from a high-quality composite material that stays warm to the touch
- If you look close, on the surface of the grip you can see the actual fibers in the material that help inhibit the heat transfer
- Do you struggle with holding steady? This grip features a flat back that helps mitigate bow hand torque and yields a more steady hold
- It also has an additional 5º angle which has also been proven to help steady your hold by relaxing the muscles in your bow arm at full draw
-
Does your hand slip on your grip? The honeycomb texture on the face of the grip provides the perfect amount of texture ensuring your hand never slips again
Â
Notes About Installation:Â
- The grip does not come with double sticky tape or adhesive
- If you use any form of adhesive the grip will be extremely hard to remove
- If the grip fits a little loose to the riser, thicken up the grip section of the riser using electrical tape or duct tape until the grip fits snugly onto the bow
- This allows for a secure fit and you can still remove the grip from the bow if you wish
-
Bows this grip fits on - All (compound) Hoyt Hunting bows made after 2006
Â
Fitment:
- Rx-3 | Rx-5: will accommodate 2021 Rx-5, Rx-5 Ultra, 2021 Rx-4 Turbo, 2020 Rx-4 Ultra, 2020 Rx-4 Alpha, 2019 Rx-3, 2019 Rx-3 Ultra, & 2019 Rx-3 Turbo
- Rx1 & Previous: Will accommodate the 2018 Rx-1, Rx-1 Ultra, 2018 Rx-1 Turbo, and any Aluminum Hoyt Hunting bow made 2018 and earlier
- For full compatibility see the chart in the manufacturer resourcesÂ